Seckit Sk-go ABL Inductive Pinda mount (M8)

prusaprinters

Pretty straight forward thing, you need one M3 nut and bolt to mount it. Probe position is #define NOZZLE_TO_PROBE_OFFSET { 20, 10, -0.9 } To setup your probe, move the nozzle until it touches the bed, put a ziptie between the probe and the bed tighten the probe nuts. -0.9 is right on and I only adjust a couple hundreds, You can use -0.8 for your offset if you want to be on the safe side, use babystepping/ liveZ to fine tune your squish at the beginning of your print. It's obviously best to print this mount in ABS since it's close to the heater bloc. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: Coex ABS White Category: 3D Printer Parts