Seat Ibiza IV(6J) Phone holder

prusaprinters

<p>Phone mount that snaps into the dashboard above the radio between the two air ducts. You may have to heat the model up and reshape the phone clip a little to hold the phone with the right amount of pressure, but the snaps should just flex into place. One blade of the clip goes into the seam between the top of the radio and the plastic part above it. The second blade on the other side of the plastic part where the air ducts are and the dashboard top. It should hold pretty secure, just be careful when removing it, as it could leave some marks or deform the plastic that it's wedged into. As long as you don't use too much force it should just pull out when flexed(pushed in and then pull up to dislodge the top clip and once the top is out pull out the bottom clip as well.</p><p>Printed in PETG, but you can use nylon, some harder TPU or even PLA if you really want, as long as it flexes a bit. I printed with 0.3mm nozzle and 0.15mm layer height, but you can use 0.6mm nozzle.</p><p>As always, Fusion files are included.</p>