Seat Ibiza 6L Vent Knob

thingiverse

The project has reached its end point. It will no longer be developed further. Edit, remix, and make any desired improvements. Regards P.S. Use the 'tapered.stl' file - it is better than the 'Final'. I have left it for you to work with if needed. _______________________________________________________________________ EDIT: 23/4/2018 - The locating part has been changed to a tapered design (.stl says 'Tapered'). This should provide a more snug fit. Hold off on trying this until I have finished printing it. Stay tuned... EDIT: 23/4/2018 - Yes, it fits much better now, feels securely located and is currently installed on the car. Download, print, install and enjoy! ________________________________________________________________________________ EDIT: 22/4/2018 - Just updated the stl. I had already exported the file from Fusion360 but made a slight mistake. The addition of 'extra meat' around the outer retaining lugs wasn't combined with the rest of the model. It was not any different from the previous version. This new version has slightly shallower dimples on the front - they were breaking through to the shell and you could see holes in the first photo. That's been fixed now. Hopefully this version will locate a bit more firmly, the last one fitted but wasn't really holding onto the vent. A good blast of hot air and it would have dropped off. It does say that this is a work in progress... ________________________________________________________________________________ I decided to design this for fun. I was sitting there, bored, waiting for my Wurth system to finish its diagnostic and I started to fiddle! Right in front of me is a vent - I start to play, and then I decide to remove the knob on the front of it! Whilst it's sat there in my hand I thought 'This would be good practice to design this in Fusion360' so I did! I used PLA. I don't expect it to do well in the heat but it's a bit of fun, white or red knobs look really striking against the rest of the interior. Enjoy!