seasucker 15x110mm thru axle (boost)

thingiverse

These adapters are crafted specifically for installation inside a seasucker HUSKE mount, allowing users to securely fasten their thru-axle bikes to the device. To ensure optimal stability and durability, we strongly recommend printing these parts with 100% infill, as this will provide a solid foundation. Additionally, consider adding a brim and orienting the print upside down to achieve the best results. The design is tailored for a snug fit on the mount; however, if yours proves too tight, simply remove some material to facilitate easy insertion and removal without compromising the adapter's grip. Nevertheless, avoid over-reducing the material, as this may cause the adapter to detach from the mount. When printing these adapters, it's essential to choose a more resilient material than PLA, which tends to soften under direct sunlight. ABS or PETG would be superior options for this purpose. Disclaimer: We acknowledge that we're presenting unproven designs and advice; use them at your own risk. Printers should exercise caution when downloading models from unknown sources, especially when the stability of their expensive equipment is at stake.