Seasoning/Gravy Packet Holder Lite

prusaprinters

<p>I finally got tired of my seasoning packets going all over the place in my cupboard so I decided to print a holder for them. All of the existing designs I could find online were either total overkill to hold some packets or used way too much plastic/time to print (or both). So I decided to make my own “lite” holder to save resources that was just sturdy enough and big enough to hold the packets together, not survive the apocalypse.</p><p>To get the cleanest, fastest print I suggest doing a 0.5-0.52mm wall line width. This way it just prints the inner and outer walls with no weird gaps to fill. This also means it prints with very few retractions and is almost like a vase mode print. I recommend setting the seam to one of the back corners for best results.</p><p>This holds approximately 8 standard packets (7 are pictured). Depending on how full they are, you might need to redistribute the powder a bit to comfortably fit all 8 when first putting them in if you don't want to bow the walls out too much.</p>