SeaDoo ST3 Fishpro Second Battery Mount

prusaprinters

<p>This holder has been designed to be glued into the hull of the fishpro.</p><p>(The photos here are of a larger Lithium battery on my first version of the battery holder.)</p><p>I have designed the holder to have a large surface area touching the hull for maximum adhesion.&nbsp;</p><p>Features:</p><p>Allowance for straps - ( i use larger Cable ties )<br>Low center of gravity.<br>Drain Holes.<br>Easy install – ( I recommend scrubbing the inside of the hull with a warm dishwashing solution and a scrubbing brush. Dry well them i used ISOPROPYL ALCOHOL to make sure there was no residue. &nbsp;Then i covered the whole underside of the printed surface with a High-performance MS sealant adhesive.. Push into place and try to force the glue to squeeze out from the perimeter of the holder. I left mine for a few days for the glue to cure.)</p><p>&nbsp;</p><p><a href="https://www.motobatt.us/MBTX20U">https://www.motobatt.us/MBTX20U</a></p><p>&nbsp;</p><p><a href="http://www.anchorman.nz">http://www.anchorman.nz</a></p><p>&nbsp;</p>