Sea-Doo Ski Pylon Support

prusaprinters

<p>Printing instructions:<br>4 perimeters<br>40% infill<br>No supports</p><p>Material:<br>Polycarbonate Blend recommended. Should work in PETG as well.</p><p>Bill of materials:<br>some glue (hot glue, super glue, epoxy… etc. pretty much any glue will work)<br>7/8" Outside Diameter PVC pipe with thick walls (thicker the better). I used grey electrical conduit.</p><p>Assembly:<br>Glue the keys into the slots on the bottom of the lower fittings. This keeps the keys from getting stuck in the lynq brackets.<br>Cut two lengths of pipe 15" long</p><p>Installation:<br>Extend the ski pylon and lynq attach points on your sea doo to their “in use” positions<br>Snap the upper fitting onto the top of the ski pylon<br>Snap the lower fittings into the lynq attach points<br>Snap in the PVC pipes, one on each side<br>Snap the locks onto the fittings to secure the pipes</p><p>Application:<br>Fit's SeaDoo 2020 GTI models including WAKE 170. May fit GTX models as well, but not tested. May fit other model years as well but untested.&nbsp;</p>