SD9VE/SIGMA Magazine Extension

cults3d

AEGIS DEFENCE CORP. MODEL: SD9-VE/SIGMA 9MM PART: CM-9-01-0A.1002 +6/7 Round Extension for standard issue SD9VE Magazine REQUIRES: x2 M3 - 4mm Cap Screws to secure extension to magazine (Length of threaded section SHALL NOT EXCEED 4mm) Minor "Stretching" of the stock spring (by 2mm) in three locations; Top, Middle, Bottom spans *PROTOTYPE (Design subject to change) *Consult local laws regarding Magazine Capacity BEFORE attempting to produce ADC and its constituents are not responsible for any damages, legal infractions or misuse. AEGIS DEFENCE CORP.™ "Defending the Future.."™ UPDATE: MK1 v2 Increased overall internal diameter by 20mm Reinforced Baseplate Interface lip Reduced size of locking tab added front reinforcement added lower shell integrity reinforcements added rear lower-to-upper reinforcement UPDATE MK1 v3: Removed Locking Tab (Interfered with lower) Added two 1.3mm "Locking" guides in baseplate-interface Added two reinforcements along each side to reduce sheering UPDATE MK1 v4: Reduced front of model by 1.2mm Reduced density of front bevel Removed front reinforcement Inverted Locking guides Removed Ledge on inner-diameter of model Added Easter-Egg UPDATE MK1 V5: REMOVED Locking Guides Increased inner diameter to prevent follower from catching Increased lower reinforcement bands Added two bores for M3 - 6mm Bolts STATUS: PROTOTYPING/TESTING PHASE: COMPLETE RELEASE ETA: RELEASED MODEL HAS BEEN DEEMED FUNCTIONAL as of 13/3/2021