SD || MicroSD card case

prusaprinters

<h5><strong>| BASIC DESCRIPTION |</strong></h5><ul><li>it is a remix of a model found here:&nbsp;</li></ul><p><a href="https://www.printables.com/model/20415-sdmicrosd-card-case">https://www.printables.com/model/20415-sdmicrosd-card-case</a></p><p><a href="https://www.printables.com/model/23326-sdmicrosd-card-case-snap-fit">https://www.printables.com/model/23326-sdmicrosd-card-case-snap-fit</a></p><ul><li>this remix has 8 slots for microSD, and one for the adapter (or a full sized SD card)</li></ul><p>&nbsp;</p><p><strong>| DESIGN DECISIONS |</strong></p><ul><li>it was also completely remodeled from ground up because I have found that the two previous models had much tighter tolerances on the micro SD cards than I wanted it to have, so I made mine a little wider and with an additional cut out so the microSD cards can be slid out easier</li><li>I really liked the snap fit on the remix so I incorporated it in my remix too</li><li>also, I wanted to make it smaller and to pack as much as microSD cards as possible in this form factor, and only one adapter - I always only need one when I am on the road</li></ul><p>&nbsp;</p><p><strong>| PRINT SETTINGS |</strong></p><ul><li><strong>General notions:</strong><ul><li>no supports required</li></ul></li></ul><p>&nbsp;</p><ul><li>The settings that I used:<ul><li><strong>Resolution:</strong> 0.15 mm</li><li><strong>Infill:</strong> 20%</li><li><strong>Filament:</strong> PETG</li></ul></li></ul>