SD Card reader holder

thingiverse

This ultimately boils down to laziness. A lot of holder type accessories had been seen on here for SD Card and MicroSD card reader extensions. The problem was that wiring had already been done, and a lot of stuff would have to be removed in order to run the cable through the back of the holder and reconnect it afterwards. So this one was made open at the top, so nothing would have to be disconnected to install it. Hopefully, it helps someone as lazy as me. This is designed for full size SD extension. Also, this was the first thing that had been made with Fusion 360, still learning. There are slight artifacts at the bottom back corners of the model, but they are so small that the slicer completely ignored them even at 0.1mm.