SD Card Holder - 12 cards

thingiverse

The foundation of this SD card holder will accommodate twelve cards at once. A chamfer at the bottom of each card slot forces cards to stand upright by 3.3mm when inserted backwards. Two types of caps are included, with the tall "t" version designed to close properly even if cards are inserted incorrectly, while the other type will not seal in such cases. The cover is secured using two socket cap screws in the design and photos shown, but a metal pin or carbon fiber rod could serve as an effective hinge pin without any issues. Printer Settings Printer: Zortrax M200 Rafts: Yes Supports: Doesn't Matter Resolution: 0.14 Infill: High Notes: For users not using the M200, it is suggested that three or four shells be used for the hinge knuckles and latch tongue to minimize potential weak points. Post-Printing Tapping It's recommended to partially tap the center knuckle while using the cap as a guide for the tap.