SD Card Brick

thingiverse

Hello! This sd card brick measures 46-34-30 mm. It has three sd cards and twelve micro sd cards capacity. PLA was used for this print. Recommended print settings: 0.1 mm layer height Two walls Around forty to fifty mm/s print speed Supports (for overhands and sliding pins) Around ten percent infill is recommended for all parts Raft was used (no heated bed) Assembly: Slide the cap into the base repeatedly to loosen up the model. Try a few sd cards to make sure there are no defects in the slots. Some light sanding may be required. The cap can be separated from the base.