SD Adapter Support for profiles

cults3d

It's a simple design, nothing complicated. I was just looking for a bracket for my micro sd extender adapter and that I could screw it to my printer profile and have it at the right angle for ease of use. I searched and didn't find anything close to what I was looking for so 1 hour (yes, I like to go slow) on Fusion360 and I was done. The 0.2 mm layer height is sufficient, but I did it at 0.15 mm. No supports, the central part is hollow and because of the angle it doesn't need supports, if you have the printer well calibrated you can print it without problems. I hope it helps someone, remixes are welcome.