Scythe Unit Boxes - Remix-new hinge

thingiverse

Family asked me to print this from "gryn"s files. I printed the first box and broke the long skinny hinge taking it off the bed. I did not like the way the box opens so I redesigned the hinge - I'm not sure if these will fit but I didn't change the dimensions of the box. I will get pictures after Christmas in the box. This design requires you to print the logo first - there are vertical bars to keep it lined up properly with the box. I printed this at .08 layer height resulting in a 2-layer print. I then removed the vertical bars that printed and the skirt I always print. Then, I printed the Unit Box directly over the logo which I did not remove from the bed. For the unit box, I printed .20 layer height - when it does the first layer of infill over the logo, the nozzle didn't touch the previously printed logo but bonded with it perfectly. I don't have a dual extruder and like this method, I've used it in the past as well. To attach the lid to the box, clean the hinge areas of any print artifacts. Insert the logo side into the hole at an angle. You will need to slightly bend the lid - I found it works best if you bend it right near the center divider in the box. Line up the other peg into the hole and slowly release the tension where you slightly bent the lid - if the peg puts pressure (not lined up in the hole), stop and back up - I did manage to crack the hinge on one box when I released the pressure and the hole wasn't aligned correctly. This is a work in progress, I'm considering adding a clip to keep the lid fully closed, for some reason they don't want to close all the way on their own. The logo files are all named similar to the remixed version - I don't own or know anything about the game, sorry if they're misspelled. There are two versions of the unit box - one is the basic box for most of the set, and one is the money box with slots for the game currency. I also included an offset lid (still lines up with the logo) and a box only - in case you need to print only half at a time. 12/22 Update - Added a pillar near the hinge hole, and updated the money box as well - I had broken three boxes in the same spot trying to get the lid on, so hopefully this will help - I'm printing one of the new ones now. Hope people like this - and I'll have some updates likely after the holiday.