SCX6 - Axle Stands

prusaprinters

<p>Axial SCX6 axle stands; separated by front and rear (since they're different). My goal was to have the strength to hold up a ~28 lbs truck, but use as little filament as possible.</p><p>You'll need to complete, two rear verticals (they're interchangeable) and the driver &amp; passenger front verticals (these matter). Along with a front and rear brace (they're different as well).</p><p>You'll also need 4 x M3x20mm cap head bolts and 4 x M3 nuts to hold it all together. The tolerance on the fitment is 0.125mm on every side, so fitment shouldn't be an issue for the center braces.</p><p><strong>Notes:&nbsp;</strong></p><p>If printed as supplied, you'll need supports under each screw holder in-dent and along the top of the front verticals. If you flip them over you won't need any supports. Just depends which side your printer does best on.</p>