SCX24 Bomber Chassis

cults3d

It's an original model, but I traced the cage shape and holes from another one. The STL is a mess of pieces but there are no hidden pockets or broken meshes. This one is pretty easy to print at the steep 60° print angle shown in the picture. Supports only touch in a few places and pull off easy. Printed in 11 hours and 28 minutes on an Ender 3 V2. Requires the special bottom trans mount piece for the SCX24 bomber. I added the one I made and one with wider rear arm spacing than the original. Build Notes: The holes are small but still work. I had to cut about a quarter inch of material off the bottom front pan to clear the servo, I don't want to change the model because that little bit makes it print better and cuts off easy. I put some foam on that platform and managed to wedge the battery up there where it seats up against the front bar perfectly. It looks soo good, couldn't be happier with how it turned out.