SCX200 Rx & vTx Antenna Mounts

thingiverse

Previously my rear props would completely destroy my vTx antenna and my Rx Frsky XSR antennas, causing them irreparable damage. But after investing in replacement parts, I designed a solution to prevent my vTx from bending towards where the props are while keeping the Tx antennas safely out of harm's way. I printed this part out of TPU, which is designed to flex in a crash and spring back into its safe zone quickly, allowing me to minimize downtime. Any other hard material would likely break on the first impact, rendering it useless. Important Note: This design requires a right-angle adapter for the vTx antenna (as shown in the side view picture). Additionally, use a 3mm tube for the Tx antennas to ensure proper fitment. To Install: While disconnecting the vTx antenna, slide this part onto it and push it up and out of the way of the hex nut portion. Then, tighten that hex nut portion to the right-angle adapter. Next, thread the two Tx antennas into their respective holes and finally mount everything to the frame. The Tx antenna holes align perfectly with the two back holes of the frame (as shown in the rear view picture).