SCX200 - Fenix R1 Pod

thingiverse

Two minor tweaks have been made; 1. The corners of the image were obscured by the pod when using a 2.1mm lens, but diagonals of the cam protection have now been removed and only a tiny amount of the pod can be seen in the corners. 2. The fin broke after a few gates so it has been made thicker; I guess it was doing its job protecting the antenna... and it worked great with turtle mode! R1.1 Printed in nylon on an Ultimaker 2+ at 0.2mm resolution, wall thickness is about 2mm with 30% infill. The camera can be hard to insert but warming the print with a hair dryer will make it more flexible and easier to put in. https://rotorbuilds.com/build/10771