SCX10 Twin I-Beam Suspension

cults3d

These files allow you to put prerunner style suspension on your SCX10 based vehicle. For the most part the pieces bolt into existing holes in the chassis rails however they do require drilling some new holes in the frame to mount some of the parts (steering rockers being one of them). The extra holes haven't been a problem thus far after extensive testing. All bolts, tie rod ends, and threaded rod used are M3 size of varying length, I don't know the exact lengths or quantities since I built it using leftover parts but a pack or M3 threaded rod and an assorted M3 bolt pack will most definitely cover all of the bolts and rods required to assemble the suspension. The steering knuckles are SCX10 knuckles using SCX10 front half shafts with the shaft section removed leaving only the hub to mount the hex and wheel.