SCX10 Tube Style Bumper

thingiverse

Hi guys, I don't really like this bumper and I can't quite figure out why, so I'm posting it as is and warning you... This is a tube front bumper similar to the SCX10 Honcho stock one (180mm and 200mm width versions (180 pictured)). Note that this version is slightly different than the picture in the way that it mounts (not clearly visible). It is shown in low position and can also be mounted 19mm higher. It uses the "Mount_3_Narrow" in a high or low mount position with the screws going in from the back of the mount (4x M2.5x8mm screws plus 2x M2.5x25-30mm screws through the mount posts for strength). Mount is here: https://www.thingiverse.com/thing:4617755 Note that I didn't cut of the bumper part of the body shell for the pictures so it will look a little different when installed properly. The bumper part of the shell will be gone and the bumper will sit about a half inch farther back. You can make your own mount similar to the one used by many of the Chinese bumpers pretty easily if that's the way you want to go, you'll just need to mount the bumper to it with screws and nuts. Use at your own risk. Wrench to drive or drive to wrench?