Sculpfun Laser 1/4" hose holder

thingiverse

These are mods of other items that I found but the originals did not fit a 1/4" hose. Other things did not fit either, so I am not even sure why they are out there. You will see in the pictures that "Front clip Laser Air Hose Holder Quarter Inch.stl" is not used. This is in case you want to use this instead of the top holder. If you use it, you will need to point your hose received at a 45-degree angle to line up with the clip hole. Print all at 100% infill to keep the parts solid, including the "Sculpfun S6 Air Assist Quarter Inch.stl". This is a tight fit, darn near perfect. The screws that held your eye protection shield is no longer needed, but I put them back in so they don't get lost. I recommend 6 clips for the hose & wire strap. Put the 1st clip near the top of the wire harness before it splits off. This will keep it from sliding around over time. I used an air inflator from Walmart ($20cad) and 3 feet of 1/4" PCV hose, which was 0.49/foot. If you want your inflator further away, buy a longer hose, but for my setup, 3 feet was perfect. - https://www.walmart.ca/en/ip/Intex-Quick-Fill-AC-Electric-Air-Pump-110-120V-Max-Air-Flow-650-L-min/PRD5I33RW15BYBL - Amazon: https://www.amazon.ca/Intex-Quick-Fill-Electric-110-120V-21-2Cfm/dp/B07F3FTCXB/ref=sr_1_4 For the air pump, snip a tiny bit of the curved tip of the attachment before putting the hose over it to help with the airflow. It'll make sense when you see it.