Screwless W1209 temperature control module case (CC-BY-NC-SA)

thingiverse

Screwless W1209 temperature control module case. With M4 mounting flap and without mounting flap. <a href='https://ko-fi.com/T6T4DXTSD' target='_blank'><img height='36' style='border:0px;height:36px;' src='https://cdn.ko-fi.com/cdn/kofi4.png?v=3' border='0' alt='Buy Me a Coffee at ko-fi.com' /></a> ##Why Needed a case for a W1209 and was short on screws. ##Design details I took the case from the "W1209 Temperature Control Switch" by Trierscheid and added the buttons from the "W1209 Thermostat Module Case" by 2Dprinter. These buttons are exactly where the screws should be. That means brass inserts are not needed for the case. The lid holds the controller in place. But I needed to do some rework on the holes (with a knife) for the sensor cable and display because on the lid these holes were slightly different from what I needed. I also added a M4 mounting flap to mount it in the Platsa printer enclosure. You can also use the flap and add it to other cases that need a mounting flap. This case does not need additional printed buttons. The buttons of the W1209 itself stick out of the case a little bit. ##Printing Instructions Print case flat Print lid upright Use supports. ##Needed Materials <ul> <li>(optional) M4x10 for mounting in cabinet <li>(optional) sharp knife to adjust hole sizes </ul> ##Assembly instruction <ol> <li>Print parts <li>Remove supports. <li>(optional) Make fit test with temperature controller and rework holes with knife <li>Insert W1209 <li>Mount cables <li>put on lid <li>(optional) mount case in cabinet <li>Done. </ol> <a href='https://ko-fi.com/T6T4DXTSD' target='_blank'><img height='36' style='border:0px;height:36px;' src='https://cdn.ko-fi.com/cdn/kofi4.png?v=3' border='0' alt='Buy Me a Coffee at ko-fi.com' /></a> (All product links are MakerBot affiliate links. If you like what I'm doing you can [Support me on Ko-Fi](https://ko-fi.com/T6T4DXTSD)) [25 May 2022]