Screwed oil lubricant bottle cap

prusaprinters

<p>If you loose the cap of an oil bottle, you can replace it with this screwed cap.</p><p>The dispenser material is most of the time made of low surface tension material. Then it is hard to glue the base on the dispenser.</p><p>What I do:</p><ul><li>Glue the bottom part with the male thread (Burette-Bouchon-r00e - I3D-1) on the dispenser.</li><li>Secure it with a very small screw on the side. In my case I found some 1.5mm x 4.5mm screws from refurbished electronics in my stock.</li></ul><p>Then you only have to screw the cap on it.</p>