Screwdriver shelf for pegboard

thingiverse

This is a screwdriver holder for a pegboard with 9x9mm square holes and a center distance of 38 mm. My first attempt involved two rows with alternating placement, allowing room for 11 screwdrivers (as shown in the initial photo). However, this version has only enough space for six screwdrivers and provides greater stability. The entire shelf is printed in PLA, except for the stabilizing component beneath the holes, which is made from Ninja Semiflex. After printing, I cut lines into it to create a star shape, ensuring the screwdriver remains stable. Based on my experience with printing using Semiflex, it's essential to print at a slow pace, extremely slowly in fact. My settings for Semiflex were as follows: Print speed: 30 Temperature: 235 degrees Celsius Bed temperature: 50 degrees Celsius (although I used double-sided tape on the bed, so zero might have been sufficient) Bottom layer speed: 15 Infill speed: 30 (not particularly relevant in this case since there is no infill present) Top/bottom speed: 15 Outer shell speed: 15 Inner shell speed: 20