Screwdriver Bit Set Holder

prusaprinters

<p>I made this to replace the horrible bit holders that came with my Wowstick 1F+. &nbsp;It is designed to hold up to 7 bits, as I noticed that was the general number of bits in a group.&nbsp;</p><p>&nbsp;</p><p>I printed this in Ninjaflex 85A, I do not recommend anything harder than that, though I suppose you might get away with 92A TPU. Also, if you will be slicing this up yourself here are a few recommended settings.</p><ul><li>2 perimeters and 0% infill.<ul><li>1 wall perimeter for the first two top layers (height range modifier.)</li></ul></li><li>Enable, “avoid crossing perimeters.”</li><li>Set seam to rear for a nicer looking part.</li></ul><p>&nbsp;</p><p>The fusion 360 and step files are attached as well in case you want to edit the design.</p>