Screw with nut and washer. 7mm x 54mm

cults3d

Human: Tighten nut with washer. Dimensions: 7mm x 54mm. This screw was engineered for use in plastic projects or materials where iron or steel contamination must be avoided. Highly tested outdoors for resistance to rust. Its strength is proven under a load of approximately 5 kg, and its diameter increases by 5% from 6mm. Recommended printing parameters are: 1) Bed temperature at 80 degrees Celsius. 2) Extruder set at 200 degrees Celsius. 3) Printing speed: 60mm/s. 4) Layer height: 0.2 mm. 5) Wall line count: 4. IMPORTANT: Before installing the nut, remove imperfections from the thread using a cutter or cutting material. These imperfections are often caused by fillers and support materials used in printing. Do not use this screw under forces greater than those specified in this document. Also available: screws with diameters of 7mm, 8mm, 9mm, 10mm, 11mm, and 12mm, or a kit including sizes from 6mm to 12mm at a promotional price. The listed price reflects the time invested in design and development, ensuring ongoing innovation and improved models.