Screw Holder (remix)

prusaprinters

First thanks to @LoboCNC for such a great design, and including the STEP file for an easy remix! The magnetic driver I'm using has a 0.39" diameter shaft, but another remix just has 4 steps in Fusion 360 (just adjust dimensions to fit your driver):Slice the body just behind the back of the screw grippers and delete the back partsExtrude the back 4 faces 0.5"Extrude the top and bottom faces by 0.02"Place a hole on the back face to “drill” out up to hex hole.In my case, I actually made the hole 0.58" deep, as my bit's hex shaft doesn't extend very much.I printed with a 0.6mm nozzle with 0.2mm layers in PLA. I did use supports everywhere, though I probably only needed supports from the build plate only.