Screw Driver Bit holder

thingiverse

I had a bunch of about one-inch bits and some longer six-inch ones just lying around. So, I built a box to store them all. The lid fits on by friction alone, but you might need to sand it down a bit to get it to fit properly - it was fine for me. The hole size in the model is 7.55 millimeters, but my printer prints about 0.4 millimeter smaller than that. I've set the target size at 7.12 millimeters, so it's just tight enough on the bits. There's also some space for craft foam in the lid to help dampen the rattling of the bits inside. It took me almost nine hours to print this out. Also, don't mind the rotation - I flipped the model around in my 3D modeling software, and the bottom is actually the side when it comes to Cura.