Screw down Wire Hanger

thingiverse

This is a screw-down wire hanger, harness, clip. Although it has two pieces, the entire thing can be printed at once without needing any additional assembly. When laid on its side as shown in the screenshot from my slicer (IdeaMaker), minimal supports are required to print it successfully. After printing, remove the two small support rods and the clip will open easily. The screw hole is designed to fit a 6 x 1 inch (or longer) deck screw, as demonstrated in the photo. The hole is made large enough for standard house wire. I created this design because I detest poorly-made nail-in clips that often result in finger injuries. This hanger also comes in handy when you need to manage existing wires and keep them organized. Its compact size allows it to fit into tight spaces with ease.