Screen Relocation Bracket

thingiverse

I came up with a bracket when I attached legs to my cr10. I wasn't happy about how much space the machine takes up, so I put it on legs, slid the controller underneath, and added a 2020 spool mount to the top. However, there's an issue with that setup: if you don't have the rear of the controller close to the z-axis, the wires will likely short out on the x-axis motor and may even pop out when printing at heights over 300mm in the z-direction. On the other hand, if you position it close enough, you won't be able to see the screen very well. And so, a relocation bracket was born! By the way, you'll need an extended 10-pin cable for this setup - I purchased mine on Amazon from https://www.amazon.com/gp/product/B00XP58LLC/ref=oh_aui_detailpage_o08_s01?ie=UTF8&psc=1 or https://www.amazon.com/gp/product/B00RFLMK5U/ref=oh_aui_detailpage_o02_s01?ie=UTF8&psc=1.