Screen Holder for Original Prusa Enclosure

prusaprinters

Fits the 5 inch HDMI touch screen (MPI5008) for the Raspberry Pi 4I purchased it from here: https://raspberry.piaustralia.com.au/collections/displays/products/5-inch-lcd-hdmi-touch-screen-display-for-raspberry-pi-4Other Requirements4 x M3 square nuts (I used the spares which came with the enclosure)4 x M3x8 screws (also from the spares which came with the enclosure)Right angle USB adapters. I used the following ones:- https://www.amazon.com.au/dp/B0B462QMMK (USB C for power)- https://www.amazon.com.au/dp/B01M0LD9L5 (USB 3.0 for webcam and printer)Assembly InstructionsInsert the square nuts into the slots in the two brackets. Use long nose pliers to get it most of the way in the a narrow allen key or screwdriver to push them in the rest of the way.Attach the brackets to the holder with two of the screws (see pics for orientation).Insert the screen by first placing the end where the USB ports are on the Raspberry Pi then push down on the other side so it clips in (flexing the end near the clip gently can help here as it is a nice snug fit)Attach to the enclosure using the remaining two screws.UpdateI noticed that the screen holder was too close to the standard controller board it was blocking the ability to turn the knob so I added another version where the mounting holes are moved by 4mm to increase the gap between the screen and the controller board. The other solution and what I did was to print a smaller knob.