Scraper - 240 mm long

thingiverse

After testing the initial scraper, I decided to upgrade it with this longer version. I was finally able to print this new design, and it turned out to be 230 mm in length. Not surprisingly, due to its great length, the tip becomes quite thin, transforming into a flexible scraper that still gets the job done. It can bend if you bend it, which should be perfect for removing excess filament or small objects from the bed that are difficult to access. To ensure optimal results, I recommend printing this scraper on its side, as printing it upright may cause steps rather than a smooth angle. To prevent warping, add supports to the corners or use a brim when printing. In my case, I started experimenting with a few supports to minimize the need for extensive trimming around the full part. Thankfully, this worked out, and the scraper functions properly even without supports. When printing multiple scrapers, I noticed that it's better to print them individually rather than together. If you print both long scrapers at once, one may move or fail to function correctly.