Scotts Speedy Green Broadcast Spreader Cable Holder Acme Thread

thingiverse

Try and print the area in the red box 100% infill. I actually did mine at 20% and it seems fine, but if I were to print again I'd do 100% FOR THAT AREA. NO SUPPORT!!. AT ALL. My printer is dialed in and this printed fine without mistake. Support will be a nightmare if not possible to remove. Again, do not use support. A RAFT is a good idea, if not a must. I used PETG but other material will work. A little different in that there's a slot and not just a small window, but just use a marker to mark your calibration. Shorter than original also, but it doesn't need to be that long.