Scotch Packaging tape dispenser

thingiverse

I fine-tuned arabon's fantastic model found at: http://www.thingiverse.com/thing:24706 Initially, there were several incomplete areas of the design which led to erratic artifacts from the Makerware slicer. Those gaps have now been seamlessly addressed, and the print is looking exceptionally good! Edit: When I printed out arabon's creation, I found that its outer diameter didn't quite fit a standard roll of packaging tape. To correct this issue, I reversed it to accommodate a 76mm (or 3 in. if you prefer that measurement) diameter, making sure it securely holds the tape. A new, revised version of the model is now live in its place. Edit #2: Upon closer inspection, it appears the teeth on the print are extremely fragile and need some tweaks. For added durability, I recommend printing with a denser infill or stronger filament (like nylon). These precautions can minimize the risk of breaking. If you have any tips or feedback, please don't hesitate to share. Instructions - Print without rafts; this will prevent them from detaching during printing. - Supporting material is necessary for the teeth and holder. With a standard resolution, it's estimated that a Replicator 2 will take approximately five hours to complete this print.