Scorpionz... With Rotating Tail And Pincers That Nip!

myminifactory

Print-in-Place design of a Scorpion. The tail spins up and over. The pincers also spin, and when squeezed, open to grasp onto objects. Another exciting print! Refer to instructions for print settings to ensure it is sturdy enough. NO SUPPORT REQUIRED. After printing, carefully snap/cut away the Raft so you don't damage the legs or Pincers in particular. As soon as the Raft is removed, the tail should spin up and over the Scorpion's back, and Princers move and nip/grasp onto objects. Take care when you first rotate the pincers so they break away cleanly. Just a gentle wiggle/twist should clear it away fine. The standard design print is approximately 17 cm in length. This can be scaled up but scaling down will not work as it will affect internal clearances and could also make the joints too weak. There is also a 'short' version (15.7 cm long) available, which has one less link in the tail. It still works fine and will enable Scorpionz to be printed on machines with smaller build plates. If rotated to 45 degrees, the model will fit on a build plate measuring 13cm x 13cm. Note: If you like this, check out all my other designs and post pictures of your prints! 'Z-REX' https://www.myminifactory.com/object/30398 'Snails' https://www.myminifactory.com/object/30353 'Fish Fossilz' https://www.myminifactory.com/object/30368 'Bugz' https://www.myminifactory.com/object/30415 'Sharkz' https://www.myminifactory.com/object/30262 'Snakez' https://www.myminifactory.com/object/30413 'Ratz' https://www.myminifactory.com/object/30361 'Crocz' https://www.myminifactory.com/object/30274 'Woodpeckerz' https://www.myminifactory.com/object/30348 'Eaglez' https://www.myminifactory.com/object/30290 'Catz' https://www.myminifactory.com/object/30296 'Piranhaz' https://www.myminifactory.com/object/30424