Scope NATO RiserMK2 picatinny / waver STANAG 4694

thingiverse

Functional and tough riser with a 75mm long rail, you adding 36.5mm offset to your scope line and look through the scope with a mask on a helmet and headphones without any problems. You'll also need two M4 screws at least 35mm long and two M4 nuts. Got questions? Like it or don't like it? Got ideas? Leave a comment, it will help me create better stuff for all of us. Make It, like It, share It. Print Settings Printer: Tevo Tarantula Rafts: Yes Supports: Yes Resolution: 0.2mm Infill: 80% Notes: Print it with a big raft (to add some bonding to the print surface) front side down like shown on the last picture. Five bottom and top solid layers. Five outline shells. Infill full honeycomb. Set your hotend temp a bit higher to get better layer bonding; I was going up from 190° to 203° (yes, PLA). Use Support Pillar Resolution: 1mm