Scion xB (2004-2006 First Gen) Cell Phone Holder for Dash

thingiverse

I designed a phone holder that prints without supports. Its purpose was to fit my Scion xB (Toaster) perfectly, providing a secure spot for my phone on the dash since standard phone holders can't accommodate the a/c vents. To use it, simply open the drawer located below the car radio and insert this device into the available slot. This will allow your phone to be held vertically while still being connected to a charger. I plan to redesign this holder in the future because my phone has slipped out during sharp left or right turns before. However, for normal driving conditions, it stays firmly in place and functions well. To prepare it for use, simply break off the thin support lines in the middle section so that you can access the charging plug area. The corners also feature extended areas to aid with lifting, which are easy to remove after printing since they're thin and break off effortlessly.