Scarlett 2i2 Open Mounting Bracket

thingiverse

I took an existing mount and modified it so that right angle 1/4 inch jacks can be plugged into the front. Could be modified further to acommadate the 2i2 rubber feet but it's good enough. I used double sided tape to secure it whilst I put in the screws. If your printer is small like mine you will need to split it, or do what I did and orientate it diagonally. Print two of these or this for the front and the original for the back. Up to you. Make sure you turn bed supports on ONLY. If you turn on all supports you will have to drill out the screw holes. https://www.thingiverse.com/thing:2603488