scania logo

thingiverse

Read instructions carefully before proceeding to print. Only the Scania V8 part is printed with support. First, print the Scania file. Then, print the Scania V8 file. This was the easy part of the print. Now comes the tricky part. Load the Scania bird black and grey right part 1 in the slicer. To print the black part, start from 0 and let it stop at 1.8 mm. For the grey part, start printing from 1.8 mm to the end. Next, load the Scania bird red and yellow right part 2 in the slicer. The red part begins at 4.2 mm; the same applies to the yellow part. Now you have four G-code files ready to print. Start with the black part, followed by the grey, then red, and finally yellow. When printing, do not remove the print from the bed. If using a heated bed, ensure your temperature remains steady while changing filament colors. Repeat this process for the Scania left files. Once complete, assemble the parts together. I used a 3D pen to weld them but you can also use glue or an alternative method. Good luck with your printing endeavor.