scania logo

cults3d

Read the instructions carefully, as this is not an easy print to do so. Only the Scania V8 part is printed with support. First, print the Scania file. Then, print the Scania V8 file. This was the simple part of the print. Now comes the tricky part. Load the Scania bird black and grey right part 1 in the slicer. For the black part, you have to print from 0 and let the print stop at 1.8 mm. For the grey part, you must print from 1.8 mm until the end. Then load the Scania bird red and yellow right part 2 in the slicer. The red part starts at 4.2 mm; the same is true for the yellow part. Now you have four G codes, and you can start printing. Begin with the black part, then the grey, then the red, and finally the yellow. When you start printing, do not remove the print from the bed. If you are printing with a heated bed, ensure your temperature stays at the right level while changing the filament color. Do the same for the Scania left files. Now you can put it together. I used a 3D pen to weld it all together, but you can also use glue or something else. Good luck printing.