scania logo

myminifactory

Read the instructions carefully, as this will not be an easy print. Only the Scania V8 part with support is printed by default. First, print the Scania file, then the Scania V8 file. This was the straightforward part of the print. Now comes the challenging part. Load the Scania bird black and grey right part 1 into the slicer. For the black part, you must start printing from 0 and stop at 1.8 mm. For the grey part, you have to begin printing from 1.8 mm until the end. Then load the Scania bird red and yellow right part 2 into the slicer. The red part begins at 4.2 mm; the same applies to the yellow part. Now you have four G-codes and can start printing. Begin with the black part, followed by the grey, then the red, and finally the yellow. When starting to print, do not remove the print from the bed. If you are using a heated bed, make sure your temperature stays at the correct level while changing the filament color. Do the same for the Scania left files. Now you can assemble it. I used a 3D pen to weld it all together, but you can also use glue or something else. Good luck with printing.