ScanGauge II Dash Mounting Bracket

prusaprinters

<p>A simple mounting bracket that clamps onto the ScanGauge II with a 10 degree angle (this can be modified in the attached .f3d file) to better angle the screen towards the driver when mounted on a declined surface on the dash like the steering column.</p><p>The clamp has a little notch that slots into the rear RJ45 port to secure and prevent the ScanGauge from sliding sideways so this will cover the rear port.</p><p>The base has an indent for a 400mm x 250mm piece of mounting tape, I recommend using <a href="https://www.bunnings.com.au/scotch-2-5cm-x-1-5m-extreme-double-sided-mounting-tape_p3961938">Scotch 2.5cm x 1.5m Extreme Double Sided Mounting Tape</a> and cut a length of 400mm for a perfect fit. Make sure to clean the mounting surface in your vehicle thoroughly with something like Isopropyl Alcohol before mounting to ensure good adhesion.</p><p>Make sure to print on the edge with the notch so you don't need to use any supports.</p>