SC2 and 200mm Noctua VR Fan Mount

prusaprinters

<p>Fan mount for SC2 Sport or Pro bolt pattern and SimLab vertical Mount.</p> <p>This is for VR use only as it would certainly be in the way of screens.</p> <p>This mount uses the long 8mm bolts extending behind the SimLab Vertical Mount and has clearance for that particular mount.</p> <p>I used this fan:<br/> Noctua NF-A20 PWM chromax.Black.swap, Premium Quiet Fan, 4-Pin (200x30mm, Black)<br/> Also a PWM controller with knob and a 12V power supply.</p> <p>This also requires 2 3" 1/4 20 hex shoulder bolts and 1/4 20 threaded knobs with a 3/4" base to fit in the hole.</p> <p>I used wood screws to attach the fan from the back.</p> <p>I did need to sand the inside of the holes to make them smooth so the knobs would fit.<br/> The hex bolts are inserted in the back and pushed through.</p> <h3>Print instructions</h3><h3>Category: Hobby Summary</h3> <p>Fan mount for SC2 Sport or Pro bolt pattern and SimLab vertical Mount.</p> <p>This is for VR use only as it would certainly be in the way of screens.</p> <p>This mount uses the long 8mm bolts extending behind the SimLab Vertical Mount and has clearance for that particular mount.</p> <p>I used this fan:<br/> Noctua NF-A20 PWM chromax.Black.swap, Premium Quiet Fan, 4-Pin (200x30mm, Black)<br/> Also a PWM controller with knob and a 12V power supply.</p> <p>This also requires 2 3" 1/4 20 hex shoulder bolts and 1/4 20 threaded knobs with a 3/4" base to fit in the hole.</p> <p>I used wood screws to attach the fan from the back.</p> <p>I did need to sand the inside of the holes to make them smooth so the knobs would fit.<br/> The hex bolts are inserted in the back and pushed through.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p>&lt;/div&gt;<strong>Rafts:</strong></div></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p>&lt;/div&gt;<strong>Resolution:</strong></div></p> <p>0.15</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>15%</p>&lt;/div&gt;<br/> <strong>Filament:</strong><br/> Prusament Galaxy Black PLA Black <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>I did need to sand the inside of the holes to make them smooth so the knobs would fit.<br/> The hex bolts are inserted in the back and pushed through.</p> <p>Also I may create a version of this with a shroud on the front to dress it up a bit.</p></div></div></p></p></p></p>