Saw Support for chop saw (Makita LS1019L)

thingiverse

Update: Have uploaded the wrong roller... NOW I hope I uploaded the correct STL... Sorry Made this to place on same table as the saw. As long you saw "deck" is ~100 mm above the table this should work for any saw... Just to support one end when working either on the out feed side or in feed. Not meant for heavy duty work but just giving the slight support needed to get good cuts. Rollers I print standing up. Need supports for bearing pocket. A-frame parts printed on it's side. Support beams printed as mounted. Once printed the washers probably needs to be sanded to size. 1.25 mm thick... they are not critical but if you use them then they probably need adjusting. ANY 1 mm thick washer that is not interfering with the rotating rollers will work... as long as the hole for the shaft is 8 mm and the diameter is smaller than the outer ring, I use 3 x 15 mm wood screws to mount lid for the 8 mm shaft. And 3.5 x 9.5 mm sheet metal screws to mount the support beams. Wood screws usually do no care if the hole is not perfectly round. But the pockets for the screw heads and the screwdriver hole under the shaft might need some reaming to work as intended when printed sideways. Hardware needed is a 8 mm 200 mm long shaft and 4 608 bearings.