Save or get Coin pusher

thingiverse

save or get The new coin pusher machine that allows you to save or win money is very easy to print and assemble. If a coin falls after insertion directly into a gap of the coin pusher it is saved. If the coin does not fall into the gap you can win a lot more :-) No supports are needed anywhere for printing. Print all parts lying flat! I have printed everything with: PLA 220 °C Resolution 0,2 Infill 5% 1 layer speed: 40mm/s Rest: 75mm/s Printing time complett: 27h PLA consumption 610g Instruction: 1. Print all parts 2. Screw the switch button into the hole on the front side of the base body 3. Screw the push rod with the countersunk screw on the gear disk but leave a gap of about 2mm so that it can move easily 4. Screw the other side of the push rod for example with a cylinder head screw to the coin slide but leave a gap of about 2mm so that it can move easily. 5. Now put the gear motor on the gear plate opposite to the push rod make sure that the shaft of the motor does not protrude from the gear disk and interfere with the push rod 6. Put the gearmotor with the screwed parts into the holder of the base body 7. Take the coin plate and insert it carefully from above at a slight angle under the coin slide until it just snaps into place on the support surface of the base body. 8. Now insert the slot into the back of the base body. 9. Plug one cable from the button switch into the + of the gear motor and the other cable into the + of the battery holder. Now connect the - from the gear motor to the - from the battery holder. 10. Then store the battery holder and the cables in the base body. 11. Place the coin container in the base body. 12. Close the base body with the cover. 13. Glue the logo in the middle of the front side 14. Finished Optional: Use 4 mm plexiglass for the cover of the base body and the slot. Just glue the plexiglass on the slot Dimensions of plexiglass for base body 174mm x 143mm x 4mm Dimensions of plexiglass for slot 168mm x 97mm x 4mm Material needed: 12mm button switch N20 gear motor with 9mm shaft, 15-30 RPM Recommended Battery compartment for 2 AA 1.5V batteries 3x approx 15cm long 1 pin cable male 3x approx 15cm long 1 pin cable female 1 piece 6mm countersunk screw 10mm long 1 piece 6mm cylinder head screw 10mm long Superglue Plexiglass I can put together a complete hardware kit for you just let me know. If you like my save or get coin pusher and would like to send me a little support you can do it this way: Paypal: https://paypal.me/SteveSchmidtPlauen?country.x=DE&locale.x=de_DE Bitcoin: bc1q6jpk67sfe9uvssdljk3u9ernp6r732eevlp9p9 Thank you very much and now have fun with gambling :-)