Sauce Saver - Inverts bottles with a nozzle to minimize waste

thingiverse

There are several bottles on the market that have built-in nozzles for effortless dispensing. However, this feature also makes it difficult to turn them upside down to get every last bit of content out. Fortunately, there's a simple solution. Just flip your bottle over and place it in a 'sauce saver' with the remaining contents flowing towards the closed nozzle. Be sure to turn it upright again for a quick second before opening and carefully releasing the nozzle to avoid any remaining content squirting out. Not every manufacturer's bottles are created equal, so before you print, verify that your cap is approximately 10mm at the tip of the nozzle, 22mm at the wide end where it meets the cap, and up to 42mm in diameter at the widest point. If your cap exceeds this size limit, simply scale up the design. Check out my other creations for more inspiring designs! To get the best results from printing this model, follow these instructions: Use Raft with a 0.20 mm layer height and standard resolution. Set your print settings to three shells and at least 20% infill to ensure durability.