Satsana Micro Swiss Direct Drive Fan Duct for CR-10S Pro V2

thingiverse

I was flabbergasted that despite the multitude of various fan ducts floating around Thingiverse, NONE of them seemed designed for the CR-10S Pro V2 and Micro Swiss. This duct is designed for: CR-10S Pro V2 BLTouch Sensor Stock fans Micro Swiss Direct Extrude*** *** Note on the Micro Swiss: I purchased the M2601 version, linked here: https://store.micro-swiss.com/products/micro-swiss-direct-drive-extruder?variant=31316019773507 though I am aware (after purchase) that you can buy the M2602 extruder-only version without the hot end, then buy the https://store.micro-swiss.com/collections/cr-10s-pro-v2/products/all-metal-hotend-kit-for-cr-10-pro 5-fin hot end. I am working on a design version update. You can see more details in the comments chain below. Use M3 screws and 2x M3 nuts to attach (I made a version with captive nuts, but found that with 3x walls you can essentially self-tap with the screws). I added a ziptie location for the cables (break off the designed-in support), modified a ton of tolerances, got the fan ducts adjusted to the proper height with the nozzle, made a permanent BLTouch mount, embossed "CR-10S Pro V2" and "Micro Swiss Direct Extrude" into it to reduce part confusion. You will have to adjust your x and y probe offset X = -50mm (50 mm left of nozzle) Y = -5mm (5 mm in front of nozzle, toward the screen) I printed without supports, 3x walls, 0.2mm resolution, 30% infill.