Satsana KingRoon KP3 5015 Fan Duct v80 Remix

thingiverse

I moved the mounting holes on the Satsana 5015 hotend/part cooling fan to line up with the Kingroon KP3 carriage. It is worth the upgrade and time spent. Leaves room on top to convert to direct drive if wanted. You can use the MODS that is for the Satsana 5015 hotend/parts cooling fan, because all I did was move the holes over. It required 2 extra m5 x 20mm screws. I also did 2 M3 x 12 screws for the mounting screws. I found that the original mounting screws was a little small. It requires a 5015 blower fan. had to splice wires and run them to the fan port on the Robin mini v2. I also suggest to updated the firmware to the latest th3d one.. Marlin 2.0.7.2 ~ If you do update. Warning. You will loose 4 top and bottom layers 3 wall layers 0.2 layer height with 50% infill no supports needed if your printer can handle over hangs. The original Kingroon KP3 can not handled overhangs without a parts cooling fan.