Satsana for Ender 3 v2 + BLtouch + Endoscope Mount for Mjolnir Direct Drive Extruder

thingiverse

First of all, I did not create the extruder, the creator is here: https://www.youtube.com/channel/UCECzwRUtrgP9lZ2tW37NIaw For the extruder, you can acquire the files or contribute to his GitHub here: https://github.com/RoyBerntsenDesign/MJOLNIR-LWX I modified the Satsana model to fit this extruder so that it sat pretty low without affecting the function. The direct drive mount for this extruder can be acquired from: https://www.thingiverse.com/thing:4821941 Suggest using prusaslicer with paint on supports, avoiding supports in internal areas that are out of reach, or you will not get them out. Bridging is best in this case. Print with the flat side on the bed, obviously. The Bltouch is also mounted as close to the nozzle as possible. -54,-6 is the probe offset. Be sure to mount the bltouch so that it either has the wires facing the negative Y direction. Alternatively, with wires facing positive y, make sure to slide the bltouch as far towards the negative Y as possible to prevent the wires from touching the endstop. Endoscope to buy and mount/arm can be found here, only need to print the inner arm: https://www.thingiverse.com/thing:3820408 edit: mjolnirsatsana_bltouch_endoscope_final2.stl has a slightly raised bltouch; it was a little close to the print surface for my liking. edit: mjolnirsatsana_bltouch_endoscope_final3.stl has an additional nut cutout on top for using a longer screw through the direct drive mount, this prevents the direct drive from lifting up when extruding fast, and dropping down when retracting. Highly recommend the latest version.