Satsana Ender 3 V2 Direct Drive (Stock parts only)

thingiverse

I wanted a direct drive conversion for my Ender 3 V2 that did not require soldering, buying new parts etc... I followed the assembly guide from [Hard Firm Soft YouTube channel](https://www.youtube.com/watch?v=W1H1l25C_zA&list=PL7NvvoJzQNbhiwtr9xOVr_w0ntYRqof2x&index=11&ab_channel=HardFirmSoft) and did end up buying an extender cable from [AliExpress](https://www.aliexpress.com/item/4000102135918.html), as recommended in the video. The original cable seems to be adequate up to a build height of 15cm, but the extender cable will help with cable management and reclaiming all of your build volume. YMMV, so please **check and test thoroughly before embarking on a long print**. I used meshmixer to combine the [main body of this](https://www.thingiverse.com/thing:4674061) with the [blower fan holder of this](https://www.thingiverse.com/thing:4647053) If you look closely, there is a small seam on the part blower duct on the right side where the two were joined. I have included the direct drive bracket I used, but this is an unmodified version from the original (https://www.thingiverse.com/thing:4674061). It has a very snug fit, and I needed to file some parts of it down to properly fit the thing.